DanaFosmer.com
  • Test Engineering
  • Electrical Engineering
  • Projects and Code
  • Archives
  • About

Guard-banding

8/30/2013

0 Comments

 
Guard-banding is the concept of tightening test limits by the amount of your measurement accuracy in the measurement system in order to prevent bad DUTs from being mistakenly passed.

For example, let’s say you are taking a measurement with a specification limit of 5 volts and the measurement system being used to measure a DUT has a measurement accuracy of 1 volt. To make sure that a DUT with a true value greater than 5 volts does not pass, the limit should be guard-banded by the 1 volt measurement accuracy and set at 4 volts.

Here is how this works. You have a DUT with a true value of 5 volts that could be measured anywhere from 4 to 6 volts due to measurement accuracy of 1 volt. See Figure 1.
Picture
Figure 1. Range of 5V true value with 1 V measurement error.
If the test limit is set at 5 volts according to the specification, then half of the time this DUT will pass and half of the time this DUT will fail. This is an example of a DUT we would want to pass, but might false fail.

Now let’s say that there was a DUT with a true value of 5.5 volts. We would never want this DUT to pass but it would pass 25% of the time. See Figure 2.
Picture
Figure 2. Range of a 5.5V true value with a risk of a false pass.
To avoid the potential of a false pass a guard-band can be applied to create a test limit of 4 volts. Now, with the limit at 4 volts the DUT with a true value of 5.5 volts from Figure 2 can never pass. See Figure 3.
Picture
Figure 3. 1 volt guard-band applied to a 5 volt true value.
It’s pretty easy to see that applying a guard-band will potentially fail more good parts. This highlights the importance of knowing where your measurement population is compared to your test limit and having an accurate measurement system. This brings up the concept of CPK which is a measurement to determine if your measurement population is too close to your limit.
0 Comments

    Archives

    December 2022
    September 2018
    March 2017
    March 2016
    October 2014
    March 2014
    August 2013
    July 2013
    August 2011
    July 2011
    February 2011
    November 2010
    October 2010
    August 2010
    June 2010
    February 2010
    January 2010

    Categories

    All
    Hardware Characterization
    Labview
    Projects
    Python
    Quality
    Test Fundamentals
    Test Hardware
    TestStand

    RSS Feed

    View my profile on LinkedIn
  • Test Engineering
  • Electrical Engineering
  • Projects and Code
  • Archives
  • About